No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6105-01-186-6988
NSN 4140-01-012-4606
NSN 5935-00-878-4641
NSN 5990-01-132-4156
NSN 4140-00-544-1517
NSN 5965-01-541-9336
NSN 4140-00-113-8215
NSN 5835-00-092-1136
NSN 5999-00-135-9007
NSN 6610-00-364-7543
NSN 6645-01-269-8377
NSN 5930-00-362-6737