No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6105-00-133-3268
NSN 6685-01-504-9486
NSN 5965-00-997-5764
NSN 6620-01-256-9703
NSN 6620-01-298-0991
NSN 5975-00-397-9533
NSN 7035-00-300-3208
NSN 5960-00-453-7846
NSN 2925-01-182-0227
NSN 6105-01-536-8993
NSN 7035-00-834-2090
NSN 5998-00-442-9325