No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5855-01-447-1648
NSN 5945-01-272-2266
NSN 5935-01-387-5500
NSN 5996-01-198-7707
NSN 5910-01-222-3902
NSN 5960-01-505-2426
NSN 6145-01-292-5441
NSN 6610-01-445-9580
NSN 5965-01-452-4189
NSN 6105-00-986-6564
NSN 6645-01-398-6841
NSN 5910-00-227-9795