2nd end, not threaded+drilled to accept plunger and spring
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5975-01-070-5096
NSN 6650-00-458-7586
NSN 7035-01-539-3781
NSN 5920-00-288-5849
NSN 6320-01-111-8851
NSN 6685-01-399-8584
NSN 5920-01-495-1268
NSN 5950-01-246-5257
NSN 5945-01-381-1356
NSN 5975-01-597-6624
NSN 6620-00-872-2108
NSN 5895-00-187-5280