No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5895-01-572-1386
NSN 2925-00-017-9807
NSN 6320-01-176-8367
NSN 6110-00-141-1966
NSN 6685-00-203-4485
NSN 5835-01-158-6878
NSN 5998-01-496-6798
NSN 6150-00-852-7040
NSN 5985-01-062-0175
NSN 5895-00-592-8220
NSN 5895-01-282-3228
NSN 6110-01-152-2778