One drill hole 0.112 in. Dia; 0.036 in. Deep each end
No other part numbers with same form, fit, and function found.
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5915-01-542-9037
NSN 5975-01-618-2471
NSN 6320-01-592-4567
NSN 6320-00-857-4073
NSN 5950-01-389-0228
NSN 6135-00-455-2425
NSN 5930-01-592-3257
NSN 6135-01-297-5565
NSN 6110-01-416-8485
NSN 6150-01-280-2733
NSN 6130-01-519-3832
NSN 5985-01-658-0278