No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 5915-00-458-9229
NSN 2925-00-969-8340
NSN 6135-00-134-6648
NSN 6620-01-016-8264
NSN 5998-01-218-8459
NSN 5998-01-068-7685
NSN 5950-01-108-3111
NSN 5930-01-386-3068
NSN 5965-00-199-4456
NSN 7035-01-067-8991
NSN 6620-01-442-7951
NSN 5998-00-175-7352