No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5915-00-186-9346
NSN 5835-01-010-3103
NSN 5985-00-594-8824
NSN 5855-00-256-5562
NSN 5998-01-147-4298
NSN 5910-00-428-2680
NSN 6135-00-196-5267
NSN 5905-01-599-9460
NSN 5835-01-096-5461
NSN 6110-00-309-2898
NSN 6620-01-189-5037
NSN 5935-01-600-0454