No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 6135-01-357-0621
NSN 5998-00-419-3459
NSN 5965-00-035-4556
NSN 6130-01-432-2855
NSN 5925-00-286-8502
NSN 5999-01-448-0431
NSN 5935-01-258-5867
NSN 5975-01-316-8956
NSN 5925-00-003-4722
NSN 5895-01-132-3779
NSN 6645-01-168-8465
NSN 5996-01-581-7372