No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 5990-01-580-2191
NSN 5835-01-026-6006
NSN 5920-01-121-8022
NSN 6320-01-029-4220
NSN 5960-01-504-3415
NSN 6105-01-302-2646
NSN 6105-01-346-5829
NSN 5996-00-701-1862
NSN 6610-01-172-3707
NSN 6130-01-234-6871
NSN 5925-00-248-5734
NSN 6105-00-071-4773