No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5895-00-820-1997
NSN 6145-01-180-9419
NSN 5905-01-154-2560
NSN 6620-01-611-4078
NSN 6105-01-396-2195
NSN 6650-01-505-0147
NSN 5999-01-450-4705
NSN 6320-00-450-7014
NSN 5998-01-350-3652
NSN 5920-01-556-7297
NSN 5905-00-375-6342
NSN 6150-01-217-6819