0.110 inch square hole first end; partial bore 0.156 inch second end
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6620-01-242-9247
NSN 5925-01-037-8175
NSN 5998-01-290-3733
NSN 6105-01-044-5405
NSN 5950-00-199-6255
NSN 5930-00-251-4619
NSN 5960-00-231-3767
NSN 5975-00-408-8152
NSN 5835-01-205-6614
NSN 5990-01-425-2175
NSN 5998-01-023-2153
NSN 2925-01-471-3365