A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 5835-01-424-4577
NSN 6685-01-232-1979
NSN 7035-01-263-5463
NSN 5925-00-182-7452
NSN 6620-01-168-8450
NSN 7035-01-106-3476
NSN 6320-00-905-0543
NSN 7035-01-316-7860
NSN 6620-01-376-3744
NSN 5935-01-396-0242
NSN 6220-01-226-1776
NSN 6220-01-330-2669