Two notches 0.562 in. W, 0.203 in. Deep located on 2nd end 2.480 in. C to c distance between notches, 1.000 in. From center of 1st notch to end, one unthd crossed drilled hole located 6.322 in. From 2nd end, 0.250 in. Dia, 0.500 in. Deep with 30 degrees countersink 0.438 in. Dia
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.O25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for lubricating holes. For items having an integral gear(s) or worm(s), see gearshaft (as modified). For items designed to support rotating members see axle(1), straight. For items not having the above conditions see pin, straight, headless. For items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5925-00-935-5287
NSN 5985-00-141-5971
NSN 6320-01-072-2073
NSN 6645-01-458-5235
NSN 5985-00-530-4835
NSN 6650-01-647-4696
NSN 5855-00-494-9581
NSN 6645-00-140-5173
NSN 6320-01-526-5534
NSN 5950-01-117-4826
NSN 6240-01-004-9634
NSN 5998-01-645-6196