Both ends 0.250 in. Diameter two cross drilled holes; groove located 2.125 in. From ea end, 0.188 in. Groove w, 1.688 in. Groove dia
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5915-00-187-8881
NSN 5920-01-587-6383
NSN 7035-01-347-4429
NSN 5835-01-327-6324
NSN 6145-00-126-1606
NSN 5930-01-361-7866
NSN 6320-01-562-1599
NSN 6145-01-386-3976
NSN 5895-01-365-0220
NSN 5930-00-009-2479
NSN 5930-00-955-6714
NSN 5935-01-240-1006