No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5915-00-968-6428
NSN 5920-01-487-2207
NSN 5960-00-266-6741
NSN 4140-01-223-3896
NSN 6645-00-796-7206
NSN 5960-01-560-1958
NSN 6105-01-628-2084
NSN 6650-01-171-6444
NSN 6645-01-077-9350
NSN 5965-01-295-4426
NSN 5905-01-293-8665
NSN 6105-00-106-0395