No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5960-00-498-9034
NSN 5945-00-502-1774
NSN 5925-01-053-6519
NSN 6240-00-635-9953
NSN 6105-00-010-9803
NSN 5855-01-136-9532
NSN 5855-01-529-6369
NSN 5930-00-636-2709
NSN 5835-01-062-2235
NSN 7035-00-252-7467
NSN 5915-00-467-1585
NSN 6145-00-753-2264