Stainless steel washer with bonded rubber back, part number 75122-per drawing.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5925-01-135-1193
NSN 5905-01-429-7513
NSN 5920-01-633-7286
NSN 5990-01-608-9271
NSN 5950-00-142-0609
NSN 5990-01-633-9503
NSN 6320-01-294-2500
NSN 2925-01-025-0082
NSN 6105-01-198-9724
NSN 5925-01-301-1596
NSN 5960-01-262-0354
NSN 2925-01-477-3787