No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5998-00-661-0380
NSN 7035-00-337-8745
NSN 6130-01-433-2215
NSN 6685-01-225-7418
NSN 6135-01-187-4382
NSN 5925-00-841-6798
NSN 6150-01-478-2005
NSN 6645-01-644-2934
NSN 6610-01-518-9888
NSN 2925-01-487-0886
NSN 6150-00-895-0610
NSN 6610-01-068-7974