No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 6645-01-420-0229
NSN 6240-01-458-1459
NSN 6105-01-132-3604
NSN 6645-00-126-0286
NSN 5895-00-019-2705
NSN 5965-01-535-5789
NSN 6320-01-338-6006
NSN 5920-00-068-5139
NSN 5835-01-191-3405
NSN 5920-00-451-6847
NSN 5855-01-184-8089
NSN 6130-01-553-5148