No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5925-00-967-6391
NSN 5960-01-495-0859
NSN 5910-01-126-2932
NSN 5930-00-257-2206
NSN 5905-00-908-1049
NSN 6685-00-354-2086
NSN 6610-01-421-4396
NSN 6645-01-286-7568
NSN 6110-00-766-0886
NSN 6150-01-452-3323
NSN 5965-01-286-6548
NSN 6240-01-438-1157