No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5920-01-472-6923
NSN 5915-01-181-2869
NSN 5855-00-548-4742
NSN 6240-01-424-4529
NSN 5996-01-338-5256
NSN 5855-01-384-3314
NSN 5895-01-287-9752
NSN 5905-01-242-9378
NSN 5996-01-360-7116
NSN 4140-00-119-1689
NSN 5930-01-274-5994
NSN 6620-01-143-9596