One edge of od chamfered 45 degrees
No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6220-00-967-0062
NSN 5975-00-279-1776
NSN 6685-01-395-5227
NSN 6650-01-504-4745
NSN 6645-01-451-1295
NSN 5999-00-468-7992
NSN 5945-01-512-9376
NSN 5985-01-056-5179
NSN 5930-01-316-2135
NSN 5895-00-632-8758
NSN 6650-01-168-1659
NSN 6610-01-273-9317