No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5950-00-243-6857
NSN 6145-00-166-7950
NSN 6130-00-086-9502
NSN 5855-01-657-7657
NSN 6105-01-545-2776
NSN 6110-01-543-8239
NSN 6240-01-178-5604
NSN 6130-00-019-3032
NSN 5930-01-570-5702
NSN 6220-01-486-6749
NSN 6645-00-435-5610
NSN 4140-01-552-8669