No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 6610-01-288-6103
NSN 5920-00-558-6792
NSN 5910-01-127-4475
NSN 5835-01-143-9143
NSN 6145-01-485-6932
NSN 5920-00-175-7987
NSN 5975-01-565-4654
NSN 6135-01-255-9129
NSN 6645-00-825-5677
NSN 6130-00-924-6238
NSN 5855-00-688-9954
NSN 6145-01-564-9574