No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6150-01-233-5723
NSN 5960-00-161-3728
NSN 6135-01-300-8455
NSN 5895-00-820-1997
NSN 5935-01-505-7713
NSN 6150-01-502-9754
NSN 6650-01-084-7377
NSN 5935-01-604-8781
NSN 5960-01-550-8038
NSN 5855-01-040-9233
NSN 6220-01-267-0651
NSN 7035-01-254-3606