No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Cotters, cotter-pins, washers and similar articles, of aluminum
NSN 5915-01-389-9499
NSN 5945-00-492-2307
NSN 6650-00-161-8127
NSN 6650-01-424-0974
NSN 2925-01-542-9403
NSN 5999-00-835-6980
NSN 6105-00-389-7994
NSN 5965-01-258-5662
NSN 5915-00-182-8068
NSN 5925-01-447-9767
NSN 6610-00-054-7276
NSN 5935-00-454-6987