No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5910-01-412-0477
NSN 6105-00-990-8707
NSN 6685-01-370-4238
NSN 6650-00-898-4215
NSN 6320-01-506-9439
NSN 5905-01-225-6027
NSN 5945-01-599-0688
NSN 6150-01-129-1348
NSN 5895-01-519-1442
NSN 5945-00-985-0559
NSN 5895-01-185-9960
NSN 6130-00-871-8090