No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5996-01-644-5405
NSN 5935-00-131-8366
NSN 6650-01-122-0169
NSN 5895-01-152-1178
NSN 5920-01-272-8902
NSN 5930-01-043-9888
NSN 5835-00-408-5499
NSN 5985-01-421-2504
NSN 5996-01-131-9353
NSN 5998-00-352-2329
NSN 6105-01-161-5024
NSN 5935-01-556-3671