A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5935-01-574-8304
NSN 5965-00-150-1144
NSN 6150-00-101-3940
NSN
NSN 5996-01-450-1743
NSN 6610-01-319-5039
NSN 5930-01-432-2481
NSN 5855-00-631-4565
NSN 6110-00-539-9543
NSN 5950-00-839-1291
NSN 5935-01-582-3817
NSN 6320-01-227-2648