No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5998-01-203-6557
NSN 6130-01-203-0588
NSN 5945-01-411-4989
NSN 6620-00-444-6972
NSN 5975-00-151-7263
NSN 6650-01-063-8356
NSN 6610-01-542-9725
NSN 4140-01-432-1447
NSN 6110-01-633-9660
NSN 6150-00-170-4515
NSN 5910-01-447-2842
NSN 5996-00-256-1718