Second end drilled 0.2515 in. Dia, 0.640 in. Deep
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 6150-01-264-1319
NSN 4140-00-168-6184
NSN 6110-01-063-8309
NSN 6685-01-381-5512
NSN 7035-00-541-8516
NSN 5975-01-219-7675
NSN 5990-01-626-3840
NSN 5999-00-727-1723
NSN 6135-01-084-1609
NSN 5945-00-419-8271
NSN 5910-01-424-8786
NSN 6150-01-494-3068