No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5999-01-116-2198
NSN 6130-01-526-7079
NSN 5855-00-288-1408
NSN 5990-01-146-9126
NSN 5975-01-562-4927
NSN 5930-01-184-7247
NSN 5965-00-246-5612
NSN 4140-01-414-3549
NSN 6650-00-287-5868
NSN 5999-01-506-7955
NSN 5920-00-382-8849
NSN 5965-01-385-1886