No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6240-01-232-2665
NSN 5945-00-477-9634
NSN 6145-01-124-9062
NSN 6150-01-236-7936
NSN 2925-00-614-1758
NSN 5990-01-373-1465
NSN 6110-00-954-0718
NSN 5935-01-580-2866
NSN 5990-01-357-6175
NSN 5990-01-411-5930
NSN 5999-00-848-2270
NSN 5915-01-187-8588