No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5915-01-032-5421
NSN 5960-01-142-1995
NSN 6145-00-122-9517
NSN 6220-01-467-2543
NSN 5996-01-472-2858
NSN 6220-01-545-8663
NSN 6610-01-342-2319
NSN 5990-01-231-9608
NSN 7035-01-260-9543
NSN 5910-01-010-3356
NSN 5835-01-114-3194
NSN 5905-00-016-3046