Pacer special
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 6130-01-051-4153
NSN 5975-01-128-4380
NSN 5950-01-654-6954
NSN 6150-01-341-9217
NSN 5920-01-634-0250
NSN 5915-01-525-7731
NSN 6145-00-548-2997
NSN 5985-01-632-2587
NSN 6130-00-247-4782
NSN 5998-01-468-8548
NSN 6610-00-097-5176
NSN 5998-00-494-5620