No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 2925-01-543-0073
NSN 5950-01-248-2241
NSN 5975-00-870-6323
NSN 6150-01-158-5938
NSN 5999-01-435-9619
NSN 6645-01-261-6903
NSN 6610-01-371-4007
NSN 5998-01-150-2590
NSN 6135-01-017-3001
NSN 5920-01-088-0707
NSN 6620-00-233-6839
NSN 5905-00-851-6336