No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 6110-01-393-7645
NSN 2925-00-660-8131
NSN 5998-00-887-2362
NSN 6320-01-551-3553
NSN 5895-00-081-9835
NSN 6150-00-466-2892
NSN 5998-01-646-1051
NSN 6105-00-229-0505
NSN 5895-01-374-2592
NSN 5910-01-475-3735
NSN 6145-01-368-3791
NSN 5935-01-227-1491