No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5950-01-503-3625
NSN 5835-00-905-7165
NSN 4140-00-119-1689
NSN 5985-01-562-8546
NSN 5920-01-336-8332
NSN 5985-01-341-6991
NSN 5960-00-351-4821
NSN 5925-01-655-3808
NSN 6610-01-099-0303
NSN 5905-00-084-7186
NSN 6130-00-015-2412
NSN 6145-01-224-7228