A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5965-01-076-0071
NSN 6135-01-604-8739
NSN 5999-01-576-7388
NSN 6220-01-170-5335
NSN 5945-01-388-1658
NSN 5960-00-681-0301
NSN 6685-01-113-8985
NSN 4140-00-892-2136
NSN 6110-00-684-6844
NSN 5965-00-861-6033
NSN 5985-01-486-1968
NSN 6130-01-358-4943