A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Washers other than lock washers, iron or steel
NSN 5915-01-047-6368
NSN 5930-01-143-6765
NSN 2925-00-041-0439
NSN 6135-01-398-5922
NSN 6145-00-557-9447
NSN 2925-01-134-9175
NSN 6145-01-188-9699
NSN
NSN 6135-01-496-5810
NSN 5905-01-138-4545
NSN 5910-00-247-2075
NSN 6135-01-448-9474