No other part numbers with same form, fit, and function found.
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6145-01-610-6916
NSN 5975-00-897-2091
NSN 5945-00-218-0012
NSN 6110-01-340-3108
NSN 5925-01-324-5260
NSN 5998-00-136-3449
NSN 5855-01-391-8176
NSN 6145-01-391-5148
NSN 5985-01-177-4338
NSN 6240-01-429-9826
NSN 2925-01-334-7122
NSN 5945-00-994-7790