Pacer special
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 6645-00-262-7448
NSN 6610-01-630-5515
NSN 6220-01-434-1886
NSN 6685-00-601-9260
NSN 6240-00-286-0742
NSN 6645-01-626-3651
NSN 5998-00-978-4474
NSN 5910-01-590-1024
NSN 5998-01-449-1803
NSN 5930-00-006-4694
NSN 6320-01-207-0636
NSN 5905-00-864-4042