Pacer special
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
NSN 6110-00-358-1870
NSN 6145-01-042-9008
NSN 5996-00-986-1122
NSN 5920-01-306-0110
NSN 6130-01-539-7629
NSN 7035-01-406-5232
NSN 5925-00-708-8769
NSN 5998-00-295-3694
NSN 5950-00-251-2310
NSN 5835-00-356-3825
NSN 5915-01-064-6059
NSN 6105-01-110-7703