A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5975-01-152-2635
NSN 6135-00-221-4720
NSN 5998-01-221-3953
NSN 5945-00-246-9528
NSN 7035-00-142-9076
NSN 5855-00-327-2112
NSN 6110-01-545-7082
NSN 6135-01-497-4516
NSN 6645-00-812-5243
NSN 5905-00-618-9091
NSN 5925-00-855-6724
NSN 6685-01-534-1597