A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 6320-00-405-2348
NSN 2925-00-149-0760
NSN 6645-01-633-1852
NSN 5996-00-147-4120
NSN 5910-01-200-7944
NSN 5945-00-274-5690
NSN 5945-00-416-5799
NSN 5935-01-158-8852
NSN 5855-01-469-2798
NSN 5990-00-138-6775
NSN 5930-00-800-3341
NSN 6110-00-260-0130