A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Copper washers including spring washers not threaded
NSN 5998-01-235-6989
NSN 6150-00-209-8026
NSN 5996-01-648-7809
NSN 5895-01-263-0224
NSN 5975-01-454-6549
NSN 5945-01-584-0059
NSN 5935-01-069-3168
NSN 5965-01-616-4826
NSN 6610-01-196-9861
NSN 5925-01-607-7712
NSN 5960-00-816-9040
NSN 6135-01-268-7056