F-16a acft; apply zinc chromate primer per tt-p-1757 while primer is still wet
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 7035-01-392-9838
NSN 6650-01-042-9360
NSN 5965-01-258-5662
NSN 5998-01-204-2500
NSN 5910-01-376-8771
NSN 5910-01-348-2815
NSN 6650-00-152-8738
NSN 6240-01-368-6248
NSN 6110-01-558-5200
NSN 5996-01-620-6550
NSN 5975-01-141-1535
NSN 5998-00-860-6308