F-16a acft; apply zinc chromate primer per tt-p-1757 while primer is still wet
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5998-00-115-2377
NSN 5950-00-139-6662
NSN 5930-00-329-0835
NSN 5910-01-195-3743
NSN 5835-00-681-0005
NSN 6110-00-144-6763
NSN 5975-01-411-3684
NSN 6145-01-415-6127
NSN 5895-01-497-0570
NSN 5945-01-519-7007
NSN 5996-01-205-8535
NSN 5855-00-494-9581