Round corners with 0.016 in. Radius on one side of washer
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use shim. For items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. Excludes disk, valve, graphite impregnated and lubricated items.
Classification: Gaskets, washers and other seals, of vulcanized rubber other than hard rubber
NSN 2925-01-448-2880
NSN 5855-01-554-5794
NSN 5910-01-523-6426
NSN 5915-01-033-4262
NSN 5999-01-327-1756
NSN 5975-01-552-7936
NSN 5950-01-659-3430
NSN 6220-00-528-7752
NSN 6145-00-237-8141
NSN 6620-01-029-3705
NSN 6645-01-418-8304
NSN 6150-00-470-7136